One miniature snap-action microswitch with pin plunger. Includes mounting hardware (not pictured): two M2 x 12mm hex socket cap screws, four M2 washers, two M2 hex nuts.
Compatible with all versions of eShapeoko and with Edward Ford's new Shapeoko motor plates.
For the Z axis of the eShapeoko, you will need a mounting solution.
Dimensions: 12.8mm long, 5.8mm thick, 6.5mm tall (excluding plunger and terminals); two 2mm diameter holes spaced at 6.5mm, centers 5mm below top of switch. The drawing is from a different microswitch of similar dimensions.
You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.
||Price per unit